Datalogic Magellan 3300HSi

38 Magellan™ 3300HSI
Image Compression
Specifies the starting image compression factor for JPEG images. A higher num-
ber specifies a higher quality image with less compression than a relative lower
number for the same image.
A value of 100 means minimal compression. A value of 1 means maximum
compression at a loss of quality. Follow these steps to program this feature:
1. Scan the START bar code.
2. Scan the Set Image Compression bar code.
3. Turn to Appendix C, and scan the two digits (zero-padded) representing
the desired compression. The configurable range is 01-0x64 by incre-
ments of 01.
4. Scan the END bar code.
Image Format
Specifies the format of the captured image
START / END
PROGRAMMING bar codes
Set Image Compression
DEFAULT SETTING IS
100 (minimal compression — higher quality)
START / END
PROGRAMMING bar codes
Image Format = JPG
DEFAULT
Image Format = BMP