146 Magellan™ 3300HSI
Maxicode (continued)
Maxicode Length 1, Length 2 Programming Instructions
1. Scan the START bar code.
2. Scan either the Set Length 1 or Set Length 2 bar code.
3. Turn to Appendix C, and scan the four digits (zero-padded) representing
the length.
NOTE
For Maxicode labels, only the data characters are included
in the length calculations.
Any value set higher than 138 will be considered to be 138.
Scan the END bar code.
START / END
PROGRAMMING bar codes
DEFAULT SETTING FOR THIS FEATURE: 0001
Set Length 1
Set Length 2
DEFAULT SETTING FOR THIS FEATURE: 0138
To Next Page
Loading...
