60 Magellan™ 3300HSI
RS-232 Interface Features (continued)
ACK NAK Retry Count
START / END
PROGRAMMING bar codes
This feature sets the number of times for the scanner to retry a label transmission under a retry condi-
tion.
000 = No retry
001 - 254 = Retry for the specified number of times
255 = Retry forever
To configure this feature, scan the “START/END” bar code above to place
the unit in Programming Mode,
then the “Set ACK NAK Retry Count,” followed by the three digits (zero padded) from the Alphanumeric
table in Appendix C,
representing your desired retry count. Exit programming mode by again scanning
the “START/END” bar code above
DEFAULT SETTING FOR THIS FEATURE: 003
Set ACK NAK Timeout Value
To Next Page
Loading...
