Datasat RS20i - 1. Input Selection; 2. EQ Selection

RS20i Installation and Operating Guide Page E-3
Appendix E. Remote Command API Document #: 9301H52900 Ver. 1.02
Input Selection Commands
1. Input Selection
Command: @INPUT<space>[input]<CR>
Operation
Response: INPUT<space>input<CR>
Read/Write
This is used to select a new input, or view the current input.
Parameters
input
Identifies the desired or selected input name. For the set
command to be successful, the name must match exactly the
input name on RS20i.
Note: Spaces may be used within the name.
See the command INPUTNAMES to extract a list of valid input
names in the current RS20i configuration.
Example
Set the Input to Oppo 95
Send: @INPUT Oppo 95<cr>
Receive: INPUT Oppo 95<cr>
2. EQ Selection
Command: @EQSET<space>[eq]<CR>
Operation
Response: EQSET <space>eq<CR>
Read/Write
This is used to select a new EQ set, or view the current EQ.
Parameters
eq
This is the EQ name which must match exactly the EQ name on
RS20i.
Note: Spaces may be used within the name.
See the command EQNAMES to extract a list of EQ names in
the current RS20i configuration.
Example
Set the EQ
Send: @EQSET eq2<cr>
Receive: EQSET eq2<cr>