RS20iInstallationandOperatingGuide
Page 20
RS20i Installation & Operating Guide Document # 9301H52900 Ver. 1.02
2.1.1 Important Safety Instructions
• Read and retain these instructions.
• Follow all instructions.
• Heed all warnings.
• Do not use this apparatus near water.
• Clean only with dry cloth.
• Do not block any ventilation openings. Install in accordance with the manufacturer’s instructions.
• Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus
(including amplifiers) that produce heat.
• Do not defeat the safety purpose of the polarized or grounding-type plug. A polarized plug has two
blades with one wider than the other. A grounding type plug has two blades and a third grounding
prong. The wide blade or the third prong are provided for your safety. If the provided plug does not
fit into your outlet, consult an electrician for replacement of the obsolete outlet.
• Protect the power cord from being walked on or pinched particularly at plugs, convenience
receptacles, and the point where it exits from the apparatus.
• Only use attachments/accessories specified by the manufacturer.
• Use only with the cart, stand, tripod, bracket, or table specified by the manufacturer,
or sold with the apparatus. When a cart is used, use caution when moving the cart
and apparatus combination to avoid injury from tip-over.
• Unplug this apparatus during lightning storms or when unused for long periods of
time.
• Refer all servicing to qualified service personnel. Servicing is required when the apparatus has
been damaged in any way, such as the power-supply cord or plug is damaged, liquid has been
spilled or objects have fallen into the apparatus, the apparatus has been exposed to rain or
moisture, and does not operate normally, or has been dropped.
Warning and Caution Notices
WARNING: Before powering on the RS20i for the first time, verify that the correct input voltage
has been selected at the rear panel power entry module. An incorrect input voltage setting will
damage the RS20i. See 2.4.4 Power Supply, page 25.
Power Cord to the RS20i rear panel: The power cord is the main disconnect device. It should be
plugged into an easily accessible outlet with surge protection. The power cord to be used is a
minimum type SVT 18/3 rated 250 Volts AC, 10 Amps with a maximum length of 4.5 M, with one
end terminated in an IEC 320 attachment plug and the other end terminated in a NEMA 5-15P
Plug.
WARNING: To reduce the risk of fire or electric shock, do not expose this apparatus to rain or
moisture. Do not expose this apparatus to dripping or splashing. No objects filled with liquids, such
as vases, shall be placed on the apparatus.
To Next Page
Loading...
