RS20iInstallationandOperatingGuide
Page 91
RS20i Installation & Operating Guide Document # 9301H52900 Ver. 1.02
4.8.3 Access Control
By creating passwords, you can control user access to the Setup GUI and/or network control of the
RS20i. To access this screen:
Setup > Access
Figure 58. Access Control Screen
1. To add or change password, select the NetCmd or Setup Password text box and use the virtual
keyboard (Figure 59).
2. Use
the Clear button on the keyboard to clear all previous text. Then, enter the new password
and select OK.
Passwords are case sensitive. You can enter upper case characters by using the Shift button on the
virtual keyboard.
Password restrictions take place as soon as the password is configured in the Access Control screen.
The Netcmd password is the password used to control access to operator-level commands from a
remote network device (such as an automation device or server) or theater management system. See
Appendix E for information on remote network control and the API commands.
An operator will be required to enter the Netcmd password for logging into the unit through VNC.
Note: Changes in the Netcmd password affect the VNC session only after the RS20i
has been reset.
A Setup password will restrict users from access to the System Setup menu. A user without the correct
password will be prohibited from making any changes to the system, inputs, network, or automation. A
VNC user also requires the Setup password to enter the Setup Menus.
The Setup password needs to be entered only once when entering the setup menus and remains in
effect until:
the RS20i is powered cycled
one hour passes with no activity
the ReLock Setup button on the Access Control screen is pushed
To Next Page
Loading...
