Datasat RS20i - Page 41


RS20iInstallationandOperatingGuide
Page 41

RS20i Installation & Operating Guide Document # 9301H52900 Ver. 1.02
Table 6. Edit Input Presets
Function Description
Copy Input Preset
Use an existing Input Preset as a template for a new one.
 Select the Input Preset you wish to copy from by selecting it from the Copy
drop down list.
 Then, touch the To box to bring up the virtual keyboard and enter a name for
the new Input Preset.
 Press the Copy button to complete the process, or press Cancel to quit.
Create Input
Preset
Select one of the pre-installed Input Presets in your RS20i and use it as a
template for a new one. The Input Preset is created with the Input Source as
described by the Input Preset name, and retains the Current EQ Setup and
current Output Preset.
 Select the Input Preset from the Create, using template drop down box.
 Then, touch the To box to bring up the virtual keyboard and enter a name for
the new Input Preset.
 Press the Create button to complete the process, or press Cancel to quit.
Rename Input
Preset
Give an existing Input Preset a new name.
 Select an existing Input Preset from the drop-down list on the right side of
the screen.
 Touch the To box to bring up the virtual keyboard and enter a new name for
the Input Preset.
 Press the Rename button to complete the process, or press Cancel to quit.
Note: Renaming the Input Preset will also change any references to that Input
Preset, such as the button assignment or the Input Preset used on Macros and
Events.
Delete Input
Preset
 Select an existing Input Preset from the Delete drop-down list on the right
side of the screen.
 Press the Delete button to complete the process, or press Cancel to quit.
Note: An Input Preset may not be deleted if it is referenced by a Button
Assignment or an Automation Event. A pop-up message will appear if the Input
Preset cannot be deleted. In that case, references to that Input Preset must first
be removed in order to delete the Input Preset.