Datasat RS20i - Page 82


RS20iInstallationandOperatingGuide
Page 82

RS20i Installation & Operating Guide Document # 9301H52900 Ver. 1.02
Ls, Rs – Left Surround and Right Surround speaker options:
 Large – (default) Mix LFE channel with this speaker.
 Small – Do not mix LFE channel with this speaker. A high pass filter is applied to the Left
Surround and Right Surround channels. Adjust the high pass frequency and slope as needed.
 Small, cross to L/R – The Left Surround will be crossed to the Left Front speaker and Right
Surround will be crossed to the Right Front speaker. Select the desired crossover filter frequency
and slope. In order to use this option, the Left and Right Front speakers should be defined as
Large. If not, an error message will appear on the screen.
 Phantom Surround. Use this if Left and Right Surround speakers are not installed. The Left
Surround channel is mixed with the Left Front speaker and the Right Surround channel is mixed
with the Right Front speaker. The offset can be adjusted.
Lb, Rb – Left Back and Right Back speaker options:
 Large – (default) Speaker can handle full range of frequencies.
 Small – A high pass filter is applied to the Left Back and right Back channels. Adjust the high
pass frequency and slope as needed.
 Small, cross to L/R – The Left Back will be crossed to the Left Front speaker and Right Back will
be crossed to the Right Front speaker. Select the desired crossover filter frequency and slope. In
order to use this option, the Left and Right Front speakers should be defined as Large. If not, an
error message will appear on the screen.
Lw, Rw – Left Wide and Right Wide speaker options:
 Large – (default) Speaker can handle full range of frequencies.
 Small – A high pass filter is applied to the Left Wide and Right Wide channels. Adjust the high
pass frequency and slope as needed.
HL, HR – High Left and High Right speaker options:
 Large – (default) select this option if the front high speakers can handle all frequencies.
 Small – A hig
h pass filter is applied to the High Left and High Right channels. Adjust the high
pass frequency and slope as needed.
 Small, cross to L/R – The High Left will be crossed to the Left Front speaker and High Right will
be crossed to the Right Front speaker. Select the desired crossover filter frequency and slope. In
order to use this option, the Left and Right Front speakers should be defined as Large. If not, an
error message will appear on the screen.
HC – High Center speaker options:
 Large – (default) select this option if the front high speakers can handle all frequencies.
 Small – A high pass filter is applied to the Center channel. Adjust the high pass frequency and
slope as needed.
 Small, cross to C – The High Center will be crossed to the Center speaker. Select the desired
crossover filter frequency and slope. In order to use this option, the Center speaker should be
defined as Large. If not, an error message will appear on the screen.
HLs, HRs – High Left Surround and High Right Surround speaker options:
 Large – (default) select this option if the high surround speakers can handle all frequencies.
 Small – A high pass filter is applied to the High Left Surround and High Right Surround channels.
Adjust the high pass frequency and slope as needed.
 Small, cross to Ls/Rs – The High Left Surround will be crossed to the Left Surround speaker
and High Right Surround will be crossed to the Right Surround speaker. Select the desired
crossover filter frequency and slope. In order to use this option, the Left Surround and Right
Surround speakers should be defined as Large. If not, an error message will appear on the
screen.
T – Top speaker options: