Operation
VMS cleaning
94897201.pdf2007-12-18
Starting cleaning or rinsing
from the touch screen
Starting cleaning and rinsing
manually
Note: Any ongoing backflush process must
first be finished before cleaning or rinsing
can be started.
1. Ensure that the milking station is in
manual mode.
2. Remove any cow that might be in the
milking station.
After treatment window
Note: Both gates should be closed to
prevent a cow from entering before the
system cleaning has been started. Closing
and opening gates is done in the Stall
control window.
3. Press the tab After Treatment on the
touch screen to display the After treatment
window.
4. In the After treatment window, press the
Cleaning and Rinsing button. This will open
the Cleaning and rinsing window.
5. The settings for the six avaliable cleaning
programs are made by the service engineer
in the management software. You can
select one of these six cleaning programs.
The selected program is the one you use
when starting manual rinsing and cleaning
from the touch screen.
If you selected the wrong type of
cleaning/rinsing or changed your mind,
press button Abort Cleaning/Rinsing to
cancel the process. Take notice that when
the cleaning is aborted, the system will
perform a draining and drying cycle anyhow.
This will take at least three minutes.
Rinsing is done with water only; system
cleanings started manually from the touch
screen are alkaline or acid. This is set by
the service engineer.
If you selected a system cleaning, change
filter sock in the milk filter unit when the
cleaning has been completed.
Recommended interval for exchanging the
100(198)
To Next Page
Loading...
