Operation
Milk sampler
94897201.pdf2007-12-18
To milk sampler milk
container
Milk pump
connection
Return line
Return line
connector
6. Remove the air-purge valve and mount
the return line connector (see picture).
7. Connect the return line to the return line
connection.
8. Turn on the vacuum to the receiver using
the manual valve.
Starting a sampling sequence
Milk sampler window
When the milk sampler has not been used
more than three days it may need to be
cleaned before being used again. That is
why the sampling sequence is normally
started just before a system cleaning.
Note: Make sure to check the settings for
milk sampling in the management software
before starting a sampling sequence. For
further information, see chapter "Milking
station" in the instruction book "VMSMgmt
2007".
Sampling is performed by using the touch
screen.
1. Press the VMS button in the top right
corner to display the VMS menu.
2. Press the Milk Sampler button to display
the Milk sampler window.
139(198)
To Next Page
Loading...
Need help?
General
