Operation
DeLaval voluntary milking system VMS
94897201.pdf2007-12-18
Common manual tasks
The following sections describe the manual
tasks that are performed common, for
example starting the milking station.
Starting the milking station for
automatic operation
Waiting for cow window
Main switch
Start button
1. Switch on the electrical power by turning
the main switch clockwise. Press the start
button, then wait as it takes a few seconds
until the Waiting for cow window appears on
the touch screen.
Note that the milking station may already be
in automatic mode after it has been started.
In this case, the instructions below should
not be carried out.
If the milking station is in manual mode:
2. In the Waiting for cow window, press the
Accept Cow button to make the station
ready to receive a cow.
3. Press the Auto button to display the Auto
and manual window.
47(198)
To Next Page
Loading...
Need help?
General
