Operation
DeLaval voluntary milking system VMS
94897201.pdf2007-12-18
When the teatcups are attached by hand, it
is important that the correct teatcup is
attached to the correct teat: for example, on
a left-side-entry station teatcup number one
should always be attached to the right rear
teat.
In automatic mode, the multi-purpose arm
automatically holds the milk tubes after
attachment of the teatcups. However, the
arm can also be made to hold the milk tubes
if the teatcups have been attached by hand.
This prevents the milk tubes from being
stepped on by the cows and the tubes from
being dragged on the floor.
See the section “Support of milk tubes” in
this chapter.
46(198)
To Next Page
Loading...
Need help?
General
