Operation
DeLaval voluntary milking system VMS
94897201.pdf2007-12-18
2) Milk delivery to the tank is delayed a
specified number of minutes after the
pick-up button has been pressed.
The milk is pumped to the tank when the
milking session is complete or the delay has
elapsed.
Instructions for both situations are provided
below.
Note that local regulations might not permit
tank emptying and milk delivery from the
VMS system at the same time.
The choice to stop or delay milk delivery to
the tank after the pick-up button has been
pressed, depends on parameter settings in
the MS config in PC. These are usually set
during the start-up of the VMS system.
Consult your service engineer if you have
questions about these settings.
For instructions about how to specify the
delay of milk delivery or, put differently, the
time milking can continue after tank
emptying has started, see chapter "Milking
station" in the instruction book "VMSMgmt
2007".
Tank emptying FCC: milk delivery to
tank is stopped immediately
Pick-up button
1. Press the yellow pick-up button on the
tank's controlling/cleaning unit.
The button will start flashing, indicating that
the VMS system has been notified that tank
emptying is about to take place. Depending
on parameter settings in the cleaning unit,
the milk will now either remain in the
receiver or be pumped over to the tank. The
milk and cleaning valve at the tank will then
switch their positions so that the delivery
line closes and the return line opens; the
tank will start stirring the milk. At this point,
the button will stop flashing and shine with
steady light.
69(198)
To Next Page
Loading...
Need help?
General
