Operation
Milk sampler
94897201.pdf2007-12-18
Location of the first
bottle
3. Select a sample bottle by typing the
bottle's number on the Milk sampler
window. Number one (1) is normally used
as the first bottle. If, however, the sampling
sequence will continue when all sample
bottles has been filled, use the coming
number after the last bottle number of the
previous rack. In other words, if the sample
tray has contained 130 bottles in the first
place, you can continue the sampling
sequence by typing the bottle number “131”.
Use the Clear button if you type the wrong
number.
4. Press the Start Sampling Milk at pos
button to start the sampling.
Stopping a sampling sequence
A sampling sequence is stopped manually
from the touch screen, after a system
cleaning.
1. Put the milking station into manual mode
and start a system cleaning. The runner
then goes to the 0 (zero) point.
2. After the system cleaning, press the Stop
Milk Sampling button on the Milk sampler
window.
Sample tray
Runner at zero
point
Control-box
cover
Sample compartment
3. With the runner still in the 0 (zero) point
position, disconnect the milk sampler from
the milking station.
Note: The sampler must be disconnected
before milking restarts to avoid milk
residues in the sampler during storage or
transportation.
4. Remove the sample tray and flush the
sample compartment. To prevent water
from damaging the electrical parts, close the
control-box cover. Make sure that the
runner is clean.
5. Check the silicone tubes for damage.
140(198)
To Next Page
Loading...
Need help?
General
