Operation
DeLaval voluntary milking system VMS
94897201.pdf2007-12-18
Attaching teatcups by hand
Teat attach and milking (left-side-entry station).
Attaching one cup at a time
Note: Ensure that the station is in manual
mode.
In this procedure, the Start Milking buttons
are used to release the teatcups.
The pictures are valid for left-side-entry
station.
1. Press the Teat attach and milking tab on
the touch screen.
Teat attach and milking (left-side-entry station).
2. Press the Start Milking (Right rear)
button. This releases teatcup Right rear and
turns the vacuum on in the milk tube. Take
the cup and attach it to teat number 1.
3. Press the Start Milking (Left rear) button.
Take the cup and attach it to teat number 2.
4. Press the Start Milking (Right front)
button. Take the cup and attach it to teat
number 3.
5. Press the Start Milking (Left front) button.
Take the cup and attach it to teat number 4.
Note: If the cow kicks off the teatcup during
a milking the "Stop Milking" button will
change to "Start Milking". Press the "Start
Milking" button and attach the cup. Note,
however, that the arm reattaches the cup if
the station is working in automatic mode.
63(198)
To Next Page
Loading...
Need help?
General
