Maintenance
DeLaval voluntary milking system VMS
94897201.pdf2007-12-18
lid
Feed
tube
Feeding
hose
4. Flush water in the funnel, through the
feed pipe and feed tube and down in the
manger. Do not use high-pressure cleaner.
5. Use a brush in the funnel and manger if
necessary. Clean the edges thoroughly. An
unclean manger causes high bacteria
growing and may make cows sick and
reluctant to enter the station.
6. To prevent mould from growing and the
feed stuff to clog together, dry blow the feed
tube, feeding hose and lid with compressed
air.
7. Dry the funnel and manger using a clean
towel.
8. Put back the second dispenser (if any)
and fasten it.
9. Close the feed tube lid by pressing the
follwing buttons on the touch screen: VMS >
Stall Control > Additional Stall Control >
Close
10. Set the service switch in operation mode.
116(198)
To Next Page
Loading...
