EasyManua.ls Logo

DeLaval VMS 2008 - Major Code 13: Vacuum Pump Alarms

Default Icon
206 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Troubleshooting
DeLaval voluntary milking system VMS
94897201.pdf2007-12-18
Vacuum pump - major code 13
M m Alarm text Type Meaning ActionM m Alarm text Type Meaning Action
13 125 VP out of oil Stop alarm Alarm issued by DeLaval vacuum
pump DVP - Oil Level Alarm.
The oil level sensor in the
lubricator has indicated little or no
oil for 24 consecutive hours. The
variable speed drive is stopped.
Refill the lubricator with oil. Reset the oil
level alarm.
13 125 VP out of oil Stop alarm Alarm issued by DeLaval vacuum
pump DVP - Oil Level Alarm.
The oil level sensor in the
lubricator has indicated little or no
oil for 24 consecutive hours. The
variable speed drive is stopped.
Refill the lubricator with oil. Reset the oil
level alarm.
13 205 VP vacuum
over the
setpoint
User
notification
Alarm issued by DeLaval vacuum
pump DVP - High Vacuum.
The vacuum has been above the
desired vacuum (Setpoint Manual
or Setpoint Milk ) more than
allowed (Over Vacuum Max ) for
more than 40 seconds.
Check that the vacuum regulator operates
properly.
13 205 VP vacuum
over the
setpoint
User
notification
Alarm issued by DeLaval vacuum
pump DVP - High Vacuum.
The vacuum has been above the
desired vacuum (Setpoint Manual
or Setpoint Milk ) more than
allowed (Over Vacuum Max ) for
more than 40 seconds.
Check that the vacuum regulator operates
properly.
13 210 VP MVR or
system
leakage fault
User
notification
Alarm issued by DeLaval vacuum
pump DVP - Low reserve.
The variable speed drive has been
operated above 95% of the
maximum speed regulation range
for more than the accepted time
(Low Reserve Max ). The fault is
cleared automatically when the
variable speed drive has operated
at 95% or below for more than a
preset time (OK Reserve Min ).
Check for leakages. Check that the vacuum
regulator is adjusted properly.
13 210 VP MVR or
system
leakage fault
User
notification
Alarm issued by DeLaval vacuum
pump DVP - Low reserve.
The variable speed drive has been
operated above 95% of the
maximum speed regulation range
for more than the accepted time
(Low Reserve Max ). The fault is
cleared automatically when the
variable speed drive has operated
at 95% or below for more than a
preset time (OK Reserve Min ).
Check for leakages. Check that the vacuum
regulator is adjusted properly.
13 240 VP no
vacuum on
high speed
User
notification
Alarm issued by DeLaval vacuum
pump DVP - No Vacuum.
The vacuum pump runs at near
maximum or maximum speed, but
can nevertheless not provide more
than a fraction of the desired
vacuum. Probably a major leakage.
Check valves and the vacuum piping.13 240 VP no
vacuum on
high speed
User
notification
Alarm issued by DeLaval vacuum
pump DVP - No Vacuum.
The vacuum pump runs at near
maximum or maximum speed, but
can nevertheless not provide more
than a fraction of the desired
vacuum. Probably a major leakage.
Check valves and the vacuum piping.
13 245 VP low oil
level
User
notification
Alarm issued by DeLaval vacuum
pump DVP - Oil Level Warning.
The oil level sensor in the
lubricator indicates that little or no
oil remains. The warning will be
cleared once the oil level is above
the minimum.
Refill the lubricator with oil.13 245 VP low oil
level
User
notification
Alarm issued by DeLaval vacuum
pump DVP - Oil Level Warning.
The oil level sensor in the
lubricator indicates that little or no
oil remains. The warning will be
cleared once the oil level is above
the minimum.
Refill the lubricator with oil.
13 250 VP time for
major service
User
notification
Alarm issued by DeLaval vacuum
pump DVP - MajorServ. Warning.
A major service of the vacuum
pump DVP is due. Required every
8000 hours.
Contact a DeLaval service engineer to
schedule a service visit.
13 250 VP time for
major service
User
notification
Alarm issued by DeLaval vacuum
pump DVP - MajorServ. Warning.
A major service of the vacuum
pump DVP is due. Required every
8000 hours.
Contact a DeLaval service engineer to
schedule a service visit.
13 251 VP time for
minor service
User
notification
Alarm issued by DeLaval vacuum
pump DVP - MinorServ. Warning.
A minor service of the vacuum
pump DVP is due. Required every
1000 hours.
See the DVP manual for instructions.13 251 VP time for
minor service
User
notification
Alarm issued by DeLaval vacuum
pump DVP - MinorServ. Warning.
A minor service of the vacuum
pump DVP is due. Required every
1000 hours.
See the DVP manual for instructions.
196(198)

Table of Contents

Related product manuals