Operation
DeLaval voluntary milking system VMS
94897201.pdf2007-12-18
Stop buttonStart button
Pick-up box
Milk-pump
button
1. To pump the milk in the receiver tank to
the storage tank, press the milk-pump
button on the pick-up box.
2. Stir the milk inside the storage tank for at
least two minutes.
3. When the stirring is complete, switch off
the cooling.
4. If desired, take a milk sample via the
manhole at the top of the tank.
5. Remove the grey cap from the tank outlet.
6. Connect the hose of the dairy truck to the
tank outlet.
7. To start the tank emptying, open the
pick-up valve by pressing the Start button
on the pick-up box. (The Stop button closes
the valve.)
9. When the tank is empty, disconnect the
hose from the tank outlet.
10. Fit the black cap on the tank outlet.
9. Start the tank cleaning.
78(198)
To Next Page
Loading...
Need help?
General
