DeLaval VMS 2008 - Page 99

Operation
DeLaval voluntary milking system VMS
94897201.pdf2007-12-18
Working
mode
FG
FG
Service mode
1. Set the service switch in working mode.
2. Let the cow enter the milking station.
3. On the touch screen, press the Waiting
for cow tab.
4. Press the Accept Cow button. Make sure
that there is no cross beside the button.
5. When the cow has entered the station,
allow some time for the cow to be identified.
1. Set the service switch in service mode.
5. Press the VMS > Robot Teaching buttons.
6. Make sure that the cow has been
identified. An identified cow indicated by the
cow number, an unidentified by 0 (zero).
- If the cow has not been identified, then
press the Identify Cow button, enter the
cow number on the keypad and confirm.
91(198)