Figure 72. Installing the battery holder assembly into the PERC shroud
NOTE: Procedure to install the other PERC card is similar.
Next steps
1. Replace the front PERC module.
2. Slide in the drive cage.
3. Replace the drive backplane.
4. Connect the drive backplane cables to the connectors on the system board and backplane.
5. Replace the drives.
6. Replace the air shroud
7. Replace the cooling fan cage assembly.
8. Replace the front top cover.
9. Follow the procedure listed in After working inside your system.
Installing and removing system components
105
To Next Page
Loading...
