1
Introduction
1-6 ineo+ 650/550/451
1.3 Descriptions and symbols for originals and paper
The use of words and symbols in this manual are explained below.
"Width" and "Length"
Whenever paper dimensions are mentioned in this manual, the first
value always refers to the width of the paper (shown as "Y" in the
illustration) and the second to the length (shown as "X").
Paper orientation
Lengthwise (w)
If the width (Y) of the paper is shorter than the length (X), the paper
has a vertical or portrait orientation, indicated by w.
Crosswise (v)
If the width (Y) of the paper is longer than the length (X), the paper
has a horizontal or landscape orientation, indicated by v.
To Next Page
Loading...
