Develop ineo+ 451 - Loading Paper into Tray 3; Loading Paper into Tray 4

ineo+ 650/550/451 2-19
Copy Operations
2
2.6 Loading paper into tray 3
1 Pull out tray 3.
2 Lift up the paper take-up roller, and then load the paper into
the tray.
– Load the paper into the tray so that the side of the paper
to be printed on (the side facing up when the package was
unwrapped) faces up.
– Load letterhead paper so that the side to be printed on
faces down.
?
How is curled paper loaded?
% Flatten the paper before loading it.
?
How many sheets of paper and other media can be
loaded?
% Do not load so many sheets of plain paper that the top of
the stack is higher than the , mark.
3 Lower the paper take-up roller, and then close tray 3.
2
Reminder
For details on selecting the size and type of paper loaded in tray 3, refer to "Copy paper" on page 2-79.
Do not load tray 3 with paper of a size other than that previously specified.
Be careful not to touch the surface of the paper take-up roller with your hands.
2
Note
To change the size of paper loaded in tray 3, contact your service representative.
To print on OHP transparencies and envelopes, use the bypass tray.