DEWESOFT SIRIUS Series

/
SIRIUS
® 
TECHNICAL REFERENCE MANUAL 


5.22.3. HS-STG: Sensor connection 
To minimize electromagnetic influence, it is recommended to use twisted pair cables. The shield of the                
cable should be connected to GNDiso on pin 4 of the DSUB-9 connector. 

HS-STG Sensor connection 

HS-STG Sensor ¼ Bridge connection 



Hint 
When your application requires a bandwidth ≥ 100 kHz, it is recommended to use external               
bridge completion. This fully symmetrical system configuration will guarantee the best           
possible noise reduction. 

 
SIRIUS
®
V20-1 251 / 336  