SIRIUS
®
TECHNICAL REFERENCE MANUAL
8.2.2.6. No synchronisation
If you use no synchronisation at all the time shift between the signals of the 2 devices will become
bigger and bigger the longer the measurement takes. At the beginning of the measurement the signals
will be very good aligned. In image below “ No sync: start of measurement ” you can only see one of the
signals, signals are completely overlapped.
No sync: start of measurement
After some time (depending on the relative clock drift of the 2 devices), you will see that the signals are
not perfectly aligned any more…
No sync: small offset
SIRIUS
®
V20-1 321 / 336
To Next Page
Loading...
