Digi DC-150 - 5.10 Adress Data Entry; 5.11 Gross Weight Display

4.8 Parts Counting Operation
4.8a Single Transaction
1. After entering unit weight by any method.
0.0000 0.1233 0
∇ ∇ ∇ ∇
. . . . . . . . . . . . . . . . . . . .
Z S N K 1 2 3 I R M I O 1 2 3 4 5 6 7 8
2. Change task (IN/OUT/NON-ADD) by
pressing [SHIFT DOWN] then [DECIMAL]
0.0000 0.1233 0
∇ ∇ ∇ ∇
key within 3 seconds. *1
. . . . . . . . . . . . . . . . . . . .
Z S N K 1 2 3 I R M I O 1 2 3 4 5 6 7 8
3. Place parts on platter.
0.3195 0.1233 2590
∇ ∇ ∇
. . . . . . . . . . . . . . . . . . . .
Z S N K 1 2 3 I R M I O 1 2 3 4 5 6 7 8
4. Print labels by pressing [ENTER] key.
0.3195 0.1233 2590
∇ ∇ ∇
. . . . . . . . . . . . . . . . . . . .
Z S N K 1 2 3 I R M I O 1 2 3 4 5 6 7 8
Note *1) Quantities received IN or shipped OUT of inventory are receoored for each ID
code. So, when counting item in ID code file, change the task on procerure 2.
Note 2) When both of IN and OUT lamps are off, the quantities do not reflect Inventory.
Note 3) To print label without counting, enter the number of parts and press ENTER
key.
124
All manuals and user guides at all-guides.com