Digi DC-150 - Auto Job Operation Mode

4.12 Auto Job Operation Mode
This mode is to show operator the next task in counting operation. Operator can
complete the counting operation by using only [ENTER] key.
Operation process can be programmed up to 5 patterns. And, a pattern can be
assigned to each of shipping, receiving, non-add operations of each ID code.
I.e. The programmed procedure; Lot No. Entry → Counting → Print Label → Operation End.
1. Stand-by Status
0.0000 0. 0
∇ ∇ ∇ ∇ ∇
. . . . . . . . . . . . . . . . . . . .
Z S N K 1 2 3 I R M I O 1 2 3 4 5 6 7 8
2. Enter ID code.
Ex.) ABC-100#125
ABC-100#125
. . . . . . . . . . . . . . . . . . . .
Z S N K 1 2 3 I R M I O 1 2 3 4 5 6 7 8
3. Press [CODE] key.
* 0.0000 0.1230 0
∇ ∇ ∇ ∇
. . . . . . . . . . . . . . . . . . . .
Z S N K 1 2 3 I R M I O 1 2 3 4 5 6 7 8
4. Change task (IN/OUT/NON-ADD) by
pressing [SHIFT DOWN] then [DECIMAL]
0.0000 0.1230 0
∇ ∇ ∇ ∇
. . . . . . . . . . . . . . . . . . . .
Z S N K 1 2 3 I R M I O 1 2 3 4 5 6 7 8
5. Press [AUTO/ Manual] key. *1
0.0000 0.1230 0
∇ ∇ ∇ ∇ ∇
. . . . . . . . . . . . . . . . . . . .
Z S N K 1 2 3 I R M I O 1 2 3 4 5 6 7 8
6. Enter Lot No.
Ex.) CAPACITOR 118E5
(15) CAPACITOR 118E5
. . . . . . . . . . . . . . . . . . . .
Z S N K 1 2 3 I R M I O 1 2 3 4 5 6 7 8
7. Press [ENTER] key.
0.0000 0.1230 0
∇ ∇ ∇ ∇ ∇
. . . . . . . . . . . . . . . . . . . .
Z S N K 1 2 3 I R M I O 1 2 3 4 5 6 7 8
128
All manuals and user guides at all-guides.com
all-guides.com