Chapter 15: Muting and Mute Groups 113
Viewing Members of Mute Groups
You can view Mute Group members in Input Channels and
FX Returns
To view the members of Mute Groups in the Inputs section:
■ Press the Show Members switch in the Mute Groups section.
The Bus Assign LEDs 1–8 at the top of each input channel strip
flash in each channel to indicate membership in the corre-
sponding Mute Group.
Actviating Mute Groups
Mute Groups are activated from the Mute Groups section on
the control surface.
To activate a Mute Group:
■ Press a Mute Groups switch 1–8 to mute the members of the
corresponding group. The Mute switches of the Mute Group
members flash to indicate they are implicitly muted.
To activate multiple Mute Groups:
■ Press any number of Mute Group switches 1–8 in any se-
quence. Mute Groups function in an additive fashion.
To deactivate a Mute Group:
■ Press a lit Mute Group switch.
Mute Groups and Explicit Mutes
After activating a Mute Group, the explicit mute status of in-
dividual channels can be toggled by pressing their Mute
switches at any time.
Any channels that are explicitly muted (before or after a Mute
Group is activated) will remain muted when the Mute Group
is deactivated.
Disabling Mute Groups
You can temporarily disable all Mute Group functions. When
Mute Groups are disabled, all channels implicitly muted as a
result of Mute Group activation are unmuted.
Channels can still be explicitly muted when Mute Groups are
disabled. Mute Group assignments are preserved and made
available again when Mute Groups are re-enabled.
To disable Mute Groups:
■ Press the Disable switch in the Mute Groups section. The
Disable switch flashes to indicated disabled state.
To re-enable Mute Groups:
■ Press the flashing Disable switch in the Mute Groups sec-
tion.
To Next Page
Loading...
Need help?
General
