EasyManuals Logo

DigiDesign D-show User Manual

DigiDesign D-show
229 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #203 background imageLoading...
Page #203 background image
Chapter 27: Troubleshooting 193
Chapter 27: Troubleshooting
This chapter provides troubleshooting and problem solving information. It includes a table of problems and solutions that pro-
vides answers to common questions, explains D-Show text messages, and refers you to specific sections later in this chapter or
elsewhere in this guide for details and instructions.
Problem Solving
The following table provides descriptions of situations that may arise while operating D-Show common questions, symptoms
and error messages, along with possible solutions.
Table 28. Troubleshooting D-Show Errors and Messages
Symptom or Message Possible Cause Solution
Faders, Switches, Channels, and Units
Fader stuck Fader path was blocked during startup cali-
bration
Reset the unit on which the stuck fader resides by right-click-
ing the unit in the Options > Devices page and choosing
Reset. If possible, wait for a silent portion of a performance
to avoid unexpected gain changes upon reset. For details,
see “Resetting Hardware Components” on page 198).
Only faders and mutes are
working
Backup personality is in effect Wait for the system to recover and follow instructions
on-screen to resume operations (see “Resuming Normal
Operation” on page 196).
Channel meter Stereo LED
is flashing
Indicates a difference of 12 dB or more
between the two sides of the stereo signal.
Trim source levels or input gains to balance.
Can’t pan an Aux from the
ACS
Aux panning is configured to follow channel
pan
In the Options > Busses page, select the Follows Channel
Pan option. Deselect for each Aux you want to pan indepen-
dently from channel pan.
Startup and Restarts
System failure and restart,
then the Resume Opera-
tions dialog appears
The D-Show system software has been
forced to restart and the backup personality
is now in effect.
Continue mixing using features available while the backup
personality is in effect (see “In Case of System Failure” on
page 195). Follow the instructions on-screen to resume oper-
ations after a restart (see “Resuming Normal Operation” on
page 196).

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the DigiDesign D-show and is the answer not in the manual?

DigiDesign D-show Specifications

General IconGeneral
BrandDigiDesign
ModelD-show
CategoryMusic Mixer
LanguageEnglish

Related product manuals