D-Show Guide172
Table 22. Snapshot data types and parameters included in each data type
Snapshot Data Type Included Parameters (for Each Scoped Channel Strip)
Fader Main volume level
Mute Mute state
EQ HPF in-circuit state; corner frequency;
EQ type selection (analog/digital); EQ in-circuit state;
4 bands (2 bands on FX Returns) of gain, freq, Q, bell/shelf selection (digital only), band on/off
Dyn Compressor/Limiter in-circuit state; threshold, ratio, attack, release, knee, makeup gain
Expander/Gate in-circuit state; threshold, ratio, attack, release, hold time, range, side-chain input
Pan Channel pan or balance/width
PQ strip balance
Pan or balance/width for each Group bus returning back to L–R
Bus Group bus assignments, group bus mono/stereo-linked state (if mono groups) or dual-mono/true stereo state (if
stereo groups), L–R bus assignment and C/M bus assignments for input strips and groups
In Input routing for Input Channels and FX Returns
Out Main out assignments; direct out assignments, level, in-circuit state, & tap-off point (excluding VCAs)
H/W Hardware insert routing and in-circuit state (excluding VCAs)
VCA VCA membership for each strip (excluding VCA strips)
Pre Gain, pad, phase, phantom power, HPF corner frequency & in-circuit state, delay time & in-circuit
Name Name for each strip
MTX Level & enable for all 12 Matrix sources plus the user send input (including tap-off point if input is a strip)
PQ Level, enable, & pan for all 12 PQ sources plus the user send input (including tap-off point if input is a strip), limiter
threshold & in-circuit state
Aux Mon On/off, pre/post selection, level, and pan/balance for each Aux/Var Group bus classified as a Monitor Aux
Aux FX On/off, pre/post selection, level, and pan/balance for each Aux/Var Group bus classified as an FX Aux
MIDI All MIDI messages that were added to the associated MIDI list for that snapshot.
Plug-Ins Rack slot settings, in-circuit state, and I/O routing for each plug-in added to plug-ins list for that snapshot