F
IGURES
– 43 –
Figure 68: Modifying Settings for Static VLANs 192
Figure 69: Showing Static VLANs 192
Figure 70: Configuring Static Members by VLAN Index 195
Figure 71: Configuring Static VLAN Members by Interface 196
Figure 72: Configuring Static VLAN Members by Interface Range 197
Figure 73: Configuring Global Status of GVRP 199
Figure 74: Configuring GVRP for an Interface 199
Figure 75: Showing Dynamic VLANs Registered on the Switch 200
Figure 76: Showing the Members of a Dynamic VLAN 200
Figure 77: QinQ Operational Concept 201
Figure 78: Enabling QinQ Tunneling 205
Figure 79: Configuring CVLAN to SPVLAN Mapping Entries 206
Figure 80: Showing CVLAN to SPVLAN Mapping Entries 207
Figure 81: Adding an Interface to a QinQ Tunnel 208
Figure 82: Configuring Protocol VLANs 210
Figure 83: Displaying Protocol VLANs 211
Figure 84: Assigning Interfaces to Protocol VLANs 212
Figure 85: Showing the Interface to Protocol Group Mapping 213
Figure 86: Configuring IP Subnet VLANs 214
Figure 87: Showing IP Subnet VLANs 215
Figure 88: Configuring MAC-Based VLANs 216
Figure 89: Showing MAC-Based VLANs 216
Figure 90: Configuring VLAN Mirroring 218
Figure 91: Showing the VLANs to Mirror 218
Figure 92: Configuring VLAN Translation 219
Figure 93: Configuring VLAN Translation 220
Figure 94: Showing the Entries for VLAN Translation 220
Figure 95: Configuring Static MAC Addresses 222
Figure 96: Displaying Static MAC Addresses 223
Figure 97: Setting the Address Aging Time 223
Figure 98: Displaying the Dynamic MAC Address Table 225
Figure 99: Clearing Entries in the Dynamic MAC Address Table 226
Figure 100: Mirroring Packets Based on the Source MAC Address 227
Figure 101: Showing the Source MAC Addresses to Mirror 227
Figure 102: STP Root Ports and Designated Ports 230
Figure 103: MSTP Region, Internal Spanning Tree, Multiple Spanning Tree 231
To Next Page