Dodge Intrepid - Crankshaft Oil Seal - Front Removal; Installation

CRANKSHAFT OIL SEAL -
FRONT
REMOVAL
(1) Remove the crankshaft sprocket. (Refer to 9 -
ENGINE/VALVE TIMING/TIMING BELT/CHAIN
AND SPROCKETS - REMOVAL)
(2) Tap the dowel pin out of the crankshaft (Fig.
72).
(3) Remove crankshaft seal using Special Tool
6341A (Fig. 73).
CAUTION: Do not nick shaft seal surface or seal
bore.
(4) Shaft seal lip surface must be free of varnish,
dirt or nicks. Polish with 400 grit paper if necessary.
INSTALLATION
(1) Install crankshaft seal using Special Tool 6342
(Fig. 74).
(2) Install the dowel pin into the crankshaft to 1.2
mm (0.047 in.) protrusion (Fig. 72).
(3) Install the crankshaft sprocket. (Refer to 9 -
ENGINE/VALVE TIMING/TIMING BELT/CHAIN
AND SPROCKETS - INSTALLATION)
Fig. 72 Crankshaft Dowel Pin - Removal/Installation
1 - PIN PUNCH
2 - DOWEL
Fig. 73 REMOVING CRANKSHAFT OIL SEAL WITH
SPECIAL TOOL
1 - SPECIAL TOOL 6341A
Fig. 74 INSTALLING CRANKSHAFT OIL SEAL WITH
SPECIAL TOOL
1 - SPECIAL TOOL 6342
9 - 136 ENGINE 3.5L LH