Dodge Intrepid User Manual

(6) Remove the 2 screws attaching the lower
shroud to the steering column (Fig. 364) . Remove
the lower shroud from the steering column.
(7) Disconnect the wiring harness connector from
the brake transmission shift interlock (BTSI) sole-
noid (Fig. 365) .
(8) Remove the retainer clip from the end of the
BTSI solenoid (Fig. 366) .
(9) Slide the BTSI solenoid straight off the shift
lever mounting stud.
INSTALLATION
(1) Align the flat inside the brake transmission
shift interlock (BTSI) solenoid (Fig. 367) with the flat
on the shift lever mounting stud.
(2) Slide the solenoid completely onto the shift
lever mounting stud aligning the plastic guide
formed into the solenoid housing with the flange on
the shift lever mechanism bracket (Fig. 368).
(3) Install the retainer clip until it snaps into
place in the slot cut into the shift lever mounting
stud (Fig. 369).
(4) Verify the BTSI solenoid is locked in place and
will not slide off the mounting stud.
(5) Connect the wiring harness connector to the
BTSI solenoid.
Fig. 364 Lower Shroud Attaching Screws
1 - LOWER SHROUD
2 - MOUNTING SCREWS
Fig. 365 Solenoid Connector
1 - BTSI SOLENOID
2 - CONNECTOR
Fig. 366 Solenoid Retainer Clip
1 - SOLENOID
2 - MOUNTING STUD
3 - RETAINER CLIP
Fig. 367 Flat Inside BTSI Solenoid
1 - GUIDES
2 - SOLENOID
3 - FLAT
LH TRANSAXLE 21 - 137
SHIFT INTERLOCK SOLENOID (Continued)

Dodge Intrepid Specifications

General

Brand	Dodge
Model	Intrepid
Category	Automobile
Language	English