Dodge Intrepid - Shift Interlock Cable Removal

torque converter into transaxle. Be sure that the hub
lugs mesh with the front pump lugs when installing.
(4) Reinstall the transaxle into the vehicle.
SHIFT INTERLOCK CABLE
REMOVAL
NOTE: Floor Shift Models
(1) Using suitable size allen wrench, remove the
gearshift knob retaining screw (Fig. 348).
(2) Remove gearshift knob from shifter assy.
(3) Remove console bezel from vehicle.
(4) Remove under panel silencer/duct assembly
(Fig. 349).
(5) Remove column cover screws.
(6) Tilt column down and remove upper half of col-
umn cover.
(7) Tilt the column to the uppermost position and
remove the tilt lever (Fig. 350).
Fig. 347 Oil Seal Installation
1 - TRANSAXLE BELL HOUSING
2 - SPECIAL TOOL C-4193A
3 - LONG STUB SHAFT
Fig. 348 Shift Handle Retaining Screw
1 - GEARSHIFT KNOB
2 - HEX WRENCH
Fig. 349 Panel Removal/Installation
1 - SILENCER/DUCT ASSEMBLY
Fig. 350 Tilt Lever Screw Removal/Install
1 - STEERING WHEEL
2 - TURN SIGNAL LEVER
3 - TILT LEVER
4 - SCREWDRIVER
21 - 132 TRANSAXLE LH
SEAL - OIL PUMP (Continued)