Dodge Intrepid - Assembly

(56) Remove low/reverse piston retainer screws
(Fig. 75).
(57) Remove low/reverse piston retainer (Fig. 76).
(58) Remove low/reverse piston retainer gasket
(Fig. 77).
ASSEMBLY
NOTE: If the transaxle assembly is being recondi-
tioned (clutch/seal replacement) or replaced, it is
necessary to perform the Quick Learn Procedure
using the DRBIIIT Scan Tool (Refer to 8 - ELECTRI-
CAL/ELECTRONIC CONTROL MODULES/TRANS-
MISSION CONTROL MODULE - STANDARD
PROCEDURE).
(1) Install the output bearing cups, use Special
Tool # 5050A (Fig. 78).
Fig. 75 Remove Piston Retainer-to-Case Screws
1 - LOW/REVERSE CLUTCH PISTON RETAINER
2 - SCREWDRIVER
3 - TORX-LOC SCREWS
Fig. 76 Remove Piston Retainer
1 - LOW/REVERSE CLUTCH PISTON RETAINER
2 - GASKET
Fig. 77 Remove Piston Retainer Gasket
1 - GASKET HOLES MUST LINE UP
2 - LOW/REVERSE CLUTCH PISTON RETAINER GASKET
Fig. 78 Bearing Cup Installation Special Tool 5050A
21 - 28 TRANSAXLE LH
42LE AUTOMATIC TRANSAXLE (Continued)