EasyManuals Logo

Dodge Intrepid User Manual

Dodge Intrepid
1050 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #811 background imageLoading...
Page #811 background image
SUN VISOR
REMOVAL
All vehicles with driver and passenger side air
bags must have a colored coded five Bullet point air-
bag warning label applied to the sun visor, verify
label availability and ensure the label is installed.
(1) Remove screw attaching inboard visor retainer
to over head. (Fig. 25).
(2) Remove screws attaching outboard visor pivot
base to roof.
(3) Disconnect visor vanity lamp wire connector, if
equipped.
(4) Remove visor from vehicle.
INSTALLATION
All vehicles with driver and passenger side airbags
must have a colored coded five bullet point airbag
warning label applied to the sun visor, verify label
availability and ensure the label is installed.
(1) Engage visor vanity lamp wire connector, if
equipped.
(2) Place visor in position on header.
(3) Install screws attaching outboard visor pivot
base to over head.
(4) Install screw attaching inboard visor retainer
to over head.
TRUNK LINING
REMOVAL
(1) Remove rear seat cushion and back.
(2) Remove fasteners at forward edge along wheel-
housing
(3) Remove spare tire board, jack, and tire.
(4) Remove fasteners at back panel and sides.
(5) Remove carpet.
INSTALLATION
(1) Fold carpet and load into position in the trunk.
(2) Install fasteners at back and sides panel.
(3) Install spare tire board, jack, and tire.
(4) Install fasteners at forward edge along wheel-
housing
(5) Install rear seat back and cushion.
UPPER QUARTER TRIM
REMOVAL
(1) Disengage clips attaching upper quarter trim
to inner quarter panel (Fig. 21).
NOTE: Start at top forward area of trim and pull
inboard.
(2) Remove seat cushion.
(3) Remove lower seat belt anchor nut.
(4) Slide seat belt through trim panel.
(5) Remove upper quarter trim from vehicle.
INSTALLATION
(1) Slide belt through trim panel.
(2) Place upper quarter trim in position on vehicle.
(3) Engage clips attaching upper quarter trim to
inner quarter panel.
NOTE: Start at lower attachments first and work up.
(4) Install seat belt anchor nut.
(5) Install seat cushion.
Fig. 25 SUN VISOR
1 - VISOR PIVOT BASE
2 - WIRE CONNECT
3 - RETAINER
4 - VISOR
23 - 74 INTERIOR LH

Table of Contents

Other manuals for Dodge Intrepid

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Dodge Intrepid and is the answer not in the manual?

Dodge Intrepid Specifications

General IconGeneral
BrandDodge
ModelIntrepid
CategoryAutomobile
LanguageEnglish

Related product manuals