SHIFT INTERLOCK SOLENOID
REMOVAL
(1) Remove the fuse panel cover from the left end
of the instrument panel (Fig. 361) .
(2) Remove the two screws behind the fuse panel
cover attaching the lower instrument panel cover to
the instrument panel (Fig. 362) .
(3) Remove the lower instrument panel cover. The
lower instrument panel cover is attached by retain-
ing clips along the top and right edge.
NOTE: The upper shroud on this steering column is
retained to the steering column by a snap fit to the
lower shroud. When removing the upper shroud
from the steering column lower shroud, DO NOT
use a hard or sharp tool. This will damage the
shrouds. If a tool must be used, use a soft tool
such as a trim stick.
(4) Remove the steering column upper shroud from
the steering column using the following procedure:
First, on the right seam between the upper and lower
shrouds, push in on seam at the forward end. When
the upper shroud unsnaps, pull the upper shroud
upward away from the lower. Repeat this procedure
on the opposite side of the column to release the
upper shroud from the lower. Remove the upper
shroud from the steering column.
(5) Remove the tilt lever (Fig. 363) from the steer-
ing column.
Fig. 360 Ignition Interlock Adjustment Tab
1 - LOCK CYLINDER HOUSING
2 - INTERLOCK CASSETTE
3 - ADJUSTMENT TAB
Fig. 361 Fuse Panel Cover
1 - FUSE PANEL COVER
2 - INSTRUMENT PANEL
Fig. 362 Lower Instrument Panel Cover Mou
1 - MOUNTING SCREWS
2 - INSTRUMENT PANEL BRACKET
3 - LOWER INSTRUMENT PANEL COVER
Fig. 363 Tilt Lever
1 - TILT LEVER
2 - LOWER SHROUD
21 - 136 TRANSAXLE LH
SHIFT INTERLOCK MECHANISM (Continued)
To Next Page
Loading...
