Dodge Intrepid - Frame & Bumpers

FRAME & BUMPERS
TABLE OF CONTENTS
page page
FRONT BUMPER REINFORCEMENT
REMOVAL .............................1
INSTALLATION ..........................1
FRONT FASCIA
REMOVAL
REMOVAL ............................2
REMOVAL - INTREPID ..................2
INSTALLATION
INSTALLATION ........................2
INSTALLATION - INTREPID ...............3
REAR BUMPER
REMOVAL .............................3
INSTALLATION ..........................4
REAR FASCIA
REMOVAL
REMOVAL ............................4
REMOVAL - INTREPID ..................4
INSTALLATION ..........................4
REAR FASCIA - INTREPID
INSTALLATION - INTREPID ................4
FRAME
SPECIFICATIONS
FRAME DIMENSIONS ...................5
SPECIFICATIONS - TORQUE .............9
ENGINE CRADLE CROSSMEMBER
REMOVAL .............................9
INSTALLATION ..........................9
FRONT TOW EYE
REMOVAL .............................10
INSTALLATION .........................10
FRONT TOW HOOK BRACKET
REMOVAL .............................10
INSTALLATION .........................10
REAR CROSSMEMBER
DESCRIPTION .........................10
OPERATION ...........................10
REMOVAL .............................11
DISASSEMBLY .........................12
ASSEMBLY ............................13
INSTALLATION .........................13
REAR TOW EYE
REMOVAL .............................15
INSTALLATION .........................15
FRONT BUMPER
REINFORCEMENT
REMOVAL
(1) Remove front fascia.
(2) Remove end plugs in ends of bumper after
removing screws in front of bumper.
(3) Remove attaching bolts from bumper reinforce-
ment to adapter plate through ends of the bumper.
(Fig. 1).
(4) If beam is damaged, the adapter plate to rail
welds will have to be cut off
INSTALLATION
(1) Place reinforcement in position on front of vehi-
cle.
(2) Install attaching bolts to inside of bumper rein-
forcement to adapter plates.
(3) Install end plugs in ends of bumper, using
screws in front of the bumper.
(4) Install front fascia.
Fig. 1 FRONT BUMPER REINFORCEMENT
1-END CAP
2-FRONT BUMPER REINFORCEMENT
3-END CAP
LH FRAME & BUMPERS 13 - 1