Dodge Intrepid - Gear Shift Cable - Column Removal

GEAR SHIFT CABLE - COLUMN
REMOVAL
(1) Place vehicle in park, and turn ignition key to
the “LOCK” position (Fig. 237) .
(2) Remove under panel silencer/duct assembly
(Fig. 238) .
(3) Remove column cover screws (Fig. 239) .
(4) Tilt column down and remove upper half of col-
umn cover (Fig. 240) .
(5) Tilt the column to the uppermost postion and
remove the tilt lever (Fig. 241).
Fig. 237 Ignition Key/Switch Positions
1 - ACC
2 - LOCK
3 - OFF
4 - ON/RUN
5-START
Fig. 238 Panel Removal/Installation
1 - SILENCER/DUCT ASSEMBLY
Fig. 239 Lower Column Cover Screw Removal
1 - LOWER COLUMN COVER
2 - STEERING WHEEL
Fig. 240 Upper Column Removal/Installation
1 - STEERING WHEEL
2 - UPPER COLUMN COVER
3 - GEAR SHIFT HANDLE
21 - 100 TRANSAXLE LH