INSTALLATION - RESERVOIR (3.5L ENGINE)
(1) Install the power steering fluid reservoir into
the mounting bracket. Be sure the retaining tab on
the bracket is holding the reservoir in the bracket.
Fasten screw to 12 N·m (105 in. lbs.).
(2) Raise vehicle.
(3) Install the power steering return hose onto the
nipple on the side of the power steering fluid reser-
voir. Install the power steering fluid supply hose
going to the power steering pump, on the bottom nip-
ple of the power steering fluid reservoir. Install the
hose clamps, being sure they are past the hose reten-
tion beads on reservoir nipples.
(4) Lower vehicle.
(5) Fill the power steering pump reservoir to cor-
rect fluid level. (Refer to 19 - STEERING/PUMP/
FLUID - STANDARD PROCEDURE)
(6) Start engine and turn steering wheel several
times from stop to stop to bleed air from fluid in sys-
tem. Stop engine, check fluid level and inspect sys-
tem for leaks.
LH PUMP 19 - 69
RESERVOIR (Continued)
To Next Page
Loading...
Need help?
General
