Dodge Intrepid - Installation - Intrepid; Rear Bumper Removal

(6) Install nut on fascia stud through the splash
shield access hole, on each side.
(7) Install fasteners attaching fascia to the front
fender and splash shield.
(8) Install grommet.
(9) Install the fasteners attaching the fascia to the
lower crossmember.
INSTALLATION - INTREPID
(1) Connect fog lamp wire connectors, if equipped.
(2) Place fascia pin position on vehicle, by fitting
foam to bumper beam.
(3) Snap sides of fascia over drive pin fasteners on
fenders.
(4) Install fasteners to upper radiator closure.
(5) Install fasteners attaching fascia to splash
shields.
(6) Install fasteners attaching bottom of fascia to
lower crossmember.
REAR BUMPER
REMOVAL
(1) Remove rear fascia.
(2) Remove attaching bolts and nuts from attach-
ing bracket to rails (Fig. 8) .
Fig. 5 FRONT BUMPER FASCIA
1 - BODY & FASCIA WIRE CONNECTORS
2 - FRONT FASCIA
Fig. 6 AIR DAM
1 - AIR DAM
2 - LOWER CROSSMEMBER
Fig. 7 FRONT BUMPER FASCIA
1 - FRONT FASCIA
2 - FOG LAMP CONNECTORS
3 - FRONT FENDER
4 - PUSH PIN FASTENER
Fig. 8 REAR BUMPER REINFORCEMENT
1 - REAR BUMPER REINFORCEMENT
LH FRAME & BUMPERS 13 - 3
FRONT FASCIA (Continued)