INSTALLATION - 3.5L
(1) Install the IAC to the throttle body (Fig. 12).
(2) Tighten mounting screws to 7.3 N·m (65 in.
lbs.) torque.
(3) Attach electrical connector to the IAC.
(4) Install air plenum and tighten the clamp.
(5) Connect the negative battery cable.
INTAKE AIR TEMPERATURE
SENSOR
REMOVAL
(1) Remove the negative battery cable.
(2) Disconnect electrical connector from sensor.
(3) Remove sensor.
INSTALLATION
(1) Install sensor. Tighten sensor.
(2) Attach electrical connector to sensor.
(3) Install the negative battery cable.
MANIFOLD TUNE VALVE
REMOVAL - 3.5L
(1) Disconnect negative battery cable.
(2) Disconnect electrical connector (Fig. 13).
(3) Remove manifold tuning valve mounting
screws. Remove tuning valve.
INSTALLATION - 3.5L
(1) Install tuning valve. Tighten mounting screws
to 11.9 N·m (105 in. lbs.) torque.
(2) Install electrical connector.
(3) Connect negative battery cable.
MAP SENSOR
DESCRIPTION
The MAP sensor mounts to the driver side of the
intake manifold plenum (Fig. 14) or (Fig. 15).
Fig. 12 Idle Air Control Motor
1 - THROTTLE POSITION SENSOR
2 - IDLE AIR CONTROL MOTOR
Fig. 13 Manifold Tuning Valve
1 - MTV VALVE
Fig. 14 MAP SENSOR 2.7L
1 - MAP SENSOR
14 - 30 FUEL INJECTION LH
IDLE AIR CONTROL MOTOR (Continued)
To Next Page
Loading...
