Dodge Intrepid - Page 404

(3) Position NEW O-rings on cover (Fig. 139).
(4) Install rear timing belt covers (Fig. 140) and
(Fig. 141). Tighten bolts to the following specified
torque:
• M10—54 N·m (40 ft. lbs.)
• M8—28 N·m (20 ft. lbs.)
Fig. 137 Rear Timing Belt Cover Bolts
1 - REAR COVER TO CYLINDER HEAD BOLTS
2 - APPLY SEALANT TO BOLT THREADS
3 - REAR COVER TO CYLINDER BLOCK BOLTS
Fig. 138 TIMING COVER REAR SEALS
1 - REAR COVER - RIGHT SIDE 3 - REAR COVER - LEFT SIDE
2 - FOAM SEAL 4 - FOAM SEALS
Fig. 139 Right Side Timing Belt Cover O-Rings
1 - O-RINGS
2 - WATER PUMP IMPELLER
LH ENGINE 3.5L 9 - 169
TIMING BELT COVER(S) - REAR (Continued)