(16) Install the reinforcement on the vehicle (Fig.
53). Install the eight bolts attaching the cowl rein-
forcement to the strut towers. Install the bolt attach-
ing the wiper module to the reinforcement.
(17) Install the covers over the wiper module and
the cowl (Fig. 52). Install and securely tighten the
attaching screws.
(18) Install the wiper arms on the pivots (Fig. 51).
Install and securely tighten the wiper arm to pivot
attaching nuts. Install the caps on the wiper arms
covering the pivot nuts.
(19) Install the battery ground cable onto the
ground stud on the shock tower and install nut.
(20) Adjust front toe. Refer to Wheel Alignment in
Suspension.
19 - 52 GEAR LH
BUSHING - INNER TIE ROD (Continued)
To Next Page
Loading...
