Dodge Intrepid - Page 630

(3) Install new front bearing (actual bearing to be
used during reassembly) onto gauge disc (special tool
6549-3) (Fig. 189).
(4) Install gauge disc and bearing into case using
gauge disc rod Tool 6549-4 (Fig. 190).
(5) Install centering disc (special tool 6494-2) onto
gauge disc rod (Fig. 191).
(6) Install centering nut Tool 6549-5 as shown in
(Fig. 192).
Fig. 189 Gauge Disc and Bearing
1 - FRONT TRANSFER SHAFT BEARING
2 - SPECIAL TOOL 6549–3
Fig. 190 Installing Gauge Disc with
1 - FRONT TRANSFER SHAFT BEARING
2 - SPECIAL TOOL 6549–3
Fig. 191 Disc Installation
1 - SPECIAL TOOL 6494–2
Fig. 192 Installing Centering Nut
1 - CENTERING NUT
2 - CENTERING DISC (6494–2)
LH TRANSAXLE 21 - 83
FINAL DRIVE (Continued)