Dodge Intrepid - Page 694

VEHICLE SPEED SIGNAL
The vehicle speed signal is calculated from the
Output Speed Sensor. The PCM converts the OSS
signal into a roughly 8000 pulse per mile vehicle
speed signal (using pinion factor information pro-
grammed into its memory), and sends it to the PCM.
The PCM, in turn, sends the vehicle speed message
across the PCI bus to the Instrument Cluster to dis-
play vehicle speed to the driver.
REMOVAL
(1) Disconnect the output speed sensor connector
(Fig. 390) .
(2) Unscrew and remove the output speed sensor.
(3) Inpsect the speed sensor o-ring and replace if
necessary (Fig. 391) .
Fig. 387 Speed Sensor Location
1 - INPUT SPEED SENSOR
2 - OUTPUT SPEED SENSOR
3 - IDENTIFICATION TAG
Fig. 388 O-Ring Location
1 - OUTPUT SPEED SENSOR
2 - O-RING
Fig. 389 Sensor Relation to Planet Carrier Park Pawl
Lugs
1 - OUTPUT SPEED SENSOR
2 - REAR PLANET CARRIER/OUTPUT SHAFT ASSEMBLY
3 - TRANSAXLE CASE
Fig. 390 Speed Sensor/Connector Location
1 - MANUAL SHIFT LEVER
2 - OUTPUT SPEED SENSOR
3 - LONG STUB SHAFT
4 - INPUT SPEED SENSOR
LH TRANSAXLE 21 - 147
SPEED SENSOR - OUTPUT (Continued)