(15) Remove regulator valve spring retainer (Fig.
429).
(16) Remove remaining retainers as shown in (Fig.
430).
(17) Remove valves and springs as shown in (Fig.
431).
(18) Cleanliness through entire disassembly and
assembly of the valve body cannot be overempha-
sized. When disassembling, each part should be
washed in a suitable solvent, then dried by com-
pressed air. Do not wipe parts with shop towels.
All mating surfaces in the valve body are accurately
machined; therefore, careful handling of all parts
must be exercised to avoid nicks or burrs.
ASSEMBLY
NOTE: If the valve body assembly is being recondi-
tioned or replaced, it is necessary to perform the
Quick Learn Procedure using the DRBIIIT Scan
Tool. (Refer to 8 - ELECTRICAL/ELECTRONIC CON-
TROL MODULES/POWERTRAIN CONTROL MODULE
- STANDARD PROCEDURE)
(1) Install valves and springs as shown in (Fig.
432).
Fig. 429 Remove Regulator Valve Spring Retainer
using Tool 6302
1 - TOOL 6302
2 - RETAINER
Fig. 430 Valve Retainer Location
1 - RETAINER
2 - RETAINER
21 - 162 TRANSAXLE LH
VALVE BODY (Continued)
To Next Page
Loading...
