Dodge Intrepid - Page 711

(2) Install regulator valve spring retainer (Fig.
433).
(3) Install dual retainer plate using Tool 6301 (Fig.
434).
(4) Verify that all retainers are installed as shown
in (Fig. 435). Retainers should be flush or below
valve body surface.
(5) Install 2/4 Accumulator components as shown
in (Fig. 436). Torque 2/4 Accumulator retainer plate
to 5 N·m (45 in. lbs.).
(6) Install check balls into position as shown in
(Fig. 437). If necessary, secure them with petrolatum
or transmission assembly gel for assembly ease.
Fig. 433 Install Regulator Valve Spring Retainer
using Tool 6302
1 - TOOL 6302
2 - RETAINER
Fig. 434 Install Dual Retainer Plate using Tool 6301
1 - TOOL 6301
2 - RETAINER
Fig. 435 Valve Retainer Location
1 - RETAINER
2 - RETAINER
Fig. 436 2/4 Accumulator Assembly
1 - VALVE BODY
2 - RETAINER PLATE
3 - DETENT SPRING
4 - SPRINGS
5 - SEALS
6 - PISTON
21 - 164 TRANSAXLE LH
VALVE BODY (Continued)