(2) Tighten the wheel lug nut, pulling the wheel
stud into the flange of the hub and bearing assembly.
When the head of the stud is fully seated against the
bearing flange, remove lug nut and washers from
wheel stud.
Fig. 33 Caliper Guide Pin Bolts
1 - BRAKE LINE
2 - CALIPER GUIDE PIN BOLTS
3 - STEERING KNUCKLE
4 - BLEEDER SCREW
5 - CALIPER ASSEMBLY
Fig. 34 Brake Rotor
1 - HUB
2 - STEERING KNUCKLE
3 - BRAKE ROTOR (DISC)
4 - WHEEL MOUNTING STUD
Fig. 35 Removing Wheel Stud From Hub And
Bearing
1 - HUB/BEARING ASSEMBLY
2 - WHEEL STUD
3 - LUG NUT
4 - SPECIAL TOOL C-4150
Fig. 36 Installing Wheel Stud Into Hub And Bearing
1 - HUB/BEARING ASSEMBLY
2 - WHEEL LUG NUT
3 - WASHERS
LH TIRES/WHEELS 22 - 21
WHEEL MOUNTING STUDS - FRONT (Continued)
To Next Page
Loading...
