Dodge Intrepid - Page 752

LATCH
REMOVAL
(1) Open decklid.
(2) Remove fasteners attaching decklid lining or
latch cover to rear of decklid as necessary.
(3) Remove bolts attaching decklid latch to decklid
(Fig. 4), (Fig. 5) or (Fig. 6).
(4) Remove decklid latch from decklid.
(5) Disconnect power lock connector from latch
solenoid.
(6) Disconnect decklid ajar switch connector from
latch.
(7) Remove latch from vehicle.
INSTALLATION
(1) Place latch in position on vehicle.
(2) Connect decklid ajar switch connector on latch.
(3) Connect power lock connector on latch solenoid.
(4) Place decklid latch in position on decklid.
(5) Install bolts to attach decklid latch to decklid.
(6) Adjust decklid latch for proper decklid to quar-
ter panel alignment and weatherstrip sealing.
(7) Install fasteners to attach decklid lining or
latch cover to rear of decklid.
(8) Verify decklid latch operation.
Fig. 4 DECK LID LATCH - CONCORDE
1 - TRUNK LID
2 - TRUNK LID CYLINDER BRACKET
3 - TRUNK LID LATCH
4 - LOCK SET
5 - TRUCK LID LOCK CYLINDER
6 - TRUNK LID OVER SLAM BUMPERS
Fig. 5 DECK LID LATCH - INTREPID
1 - LOCK CYLINDER BRACKET
2 - LOCK SET
3 - TRUNK LID
4 - TRUNK LID LATCH
5 - TRUNK LOCK CYLINDER
Fig. 6 DECK LID LATCH - 300M
1 - LOCK CYLINDER BRACKET AND LOCK CYLINDER
2 - LOCK SET
3 - TRUNK LID LATCH
4 - TRUNK LID
LH DECKLID 23 - 15