Dodge Intrepid - Page 760

LOCK CYLINDER
REMOVAL
(1) Remove door trim panel. (Refer to 23 - BODY/
DOOR - FRONT/TRIM PANEL - REMOVAL)
(2) Remove water shield, as necessary
(3) Raise door glass.
(4) Disengage clip holding lock link to lock cylin-
der.
(5) Disconnect link from lock cylinder.
(6) Disconnect clip attaching lock cylinder to door
handle.
(7) Pull lock cylinder from door handle (Fig. 10).
INSTALLATION
(1) Push lock cylinder into socket on door handle.
(2) Insert link into clip on lock cylinder.
(3) Engage clip to fasten lock link to lock cylinder.
(4) Verify lock operation.
(5) Install watershield.
(6) Install door trim panel. (Refer to 23 - BODY/
DOOR - FRONT/TRIM PANEL - INSTALLATION)
SIDE VIEW MIRROR FLAG
REMOVAL
(1) Pull cover, release clips and remove (Fig. 11).
(2) Remove the bolts and remove the bracket, if
necessary.
INSTALLATION
(1) If previously removed, install the door bracket
and bolts.
(2) Install the cover and engage the clips (Fig. 11).
Fig. 10 DOOR LOCK CYLINDER
1 - CLIP
2 - LOCK CYLINDER
3 - DOOR HANDLE
Fig. 11 MIRROR FLAG COVER W/O SPEAKER
1 - FRONT DOOR COVER W/O SPEAKER
2 - FRONT DOOR BRACKET
LH DOOR - FRONT 23 - 23